2004 Chevrolet Corvette
Mileage
69,233
Service Date
7/7/2021
Services Performed
- -INITIALLY, THERE WAS ONLY A SERVICE TIRE PRESSURE MONITOR MESSAGE ON THE DASH -SCANNED ALL SENSORS, ALL SENSORS WERE READING. THE DASH HOWEVER, WAS NOT DISPLAYING THE RIGHT FRONT AND THE LEFT REAR PRESSURES. -RESET/REPROGRAMMED THE TPMS SYSTEM AND CLEARED THE CODES STORED IN THE REMOTE FUNCTION MODULE. TEST DROVE THE VEHICLE 7 MILES AND THE MESSAGE DID NOT RETURN. *IF THE ISSUE RETURNS, RECOMMEND REPLACING THE TPMS SENSORS AND RETESTING. -THERE WERE NO STABILITY CONTROL LIGHTS ON THE DASH INITIALLY. THERE WERE ALSO 30 CODES STORED THROUGHOUT ALL MODULES RELATED TO BATTERY VOLTAGE LOSS (ALL CODES WERE HISTORY CODES. -CLEARED ALL CODES AND TEST DROVE THE VEHICLE TO SEE IF ANYTHING RETURNED. NO CODES RETURNED DURING THE TEST DRIVE BUT THE ACTIVE HANDLING MESSAGE ILLUMINATED RANDOMLY THROUGHOUT THE DRIVE. -MONITORED THE SENSOR INPUTS IN THE ABS MODULE AND FOUND THAT THERE WAS NO CHANGE TO THE STEERING ANGLE SENSOR READINGS WHEN TURNING THE WHEEL. -WHILE MONITORING THE READINGS, THE TRACTION CONTROL LIGHT CAME ON AND THE SERVICE ACTIVE HANDLING MESSAGE ILLUMINATED ON THE DASH. -SCANNED FOR CODES AGAIN C1287 ANTILOCK BRAKE SYSTEM -DUE TO THE STEERING ANGLE SENSOR NOT READING, IT CAN CAUSE THE C1287 CODE. -WERIFIED GOOD CONNECTION AT THE STEERING ANGLE SENSOR. *RECOMMEND REPLACEMENT OF THE STEERING ANGLE SENSOR, CLEARING CODES, AND TEST DRIVING THE VEHICLE TO VERIFY THAT THE ISSUE DOESN'T RETURN.
- -VERIFIED THAT THERE IS NO ILLUMINATION IN THE HUD UNIT. -THERE IS WAS VERY WEAK AND LIMITED MOTOR MOVEMENT INITIALLY AND THEN IT STOPPED MOVING COMPLETELY. -WOULD HAVE TO START WITH REPLACEMENT OF THE HEADS UP DISPLAY UNIT AND RETEST. *REPLACEMENT OF THE HEADS UP DISPLAY UNIT REQUIRES REMOVAL OF THE DASH. THERE IS A HIGH LIKELIHOOD OF CRACKING OR OTHER DAMAGE TO THE DASH AND TRIM PIECES DURING REMOVAL AND INSTALLATION DUE TO THE AGE AND QUALITY OF THE PLASTICS.
- -IT IS POSSIBLE TO REPLACE THE EMBLEM. BUT DUE TO IT BEING GLUED ON FROM THE FACTORY, THERE IS A POSSIBILITY OF DAMAGE TO THE PAINT DURING REMOVAL OF THE OLD EMBLEM DUE TO IT BEING NECESSARY TO USE HIGH HEAT APPLICATION TO MELT THE GLUE. -RECOMMEND HAVING A BODY SHOP INSTALL EMBLEM
- *AFTER REPLACEMENT OF THE STEERING WHEEL POSITION SENSOR, CLEARED CODES AND TEST DROVE THE VEHICLE. NO WARNINGS CAME UP ON THE DASH AND NO CODES HAVE RETURNED. ***THERE ARE NO LIGHTS OR MESSAGES ON THE DASH AT THIS TIME***
- SAVI RANCH AUTOMOTIVE OIL CHANGE SPECIAL.
- LUBRICATE AND CHECK CHASSIS. CHANGE OIL AND OIL FILTER. CHECK ENGINE AIR FILTER, BREATHER FILTER, AND CABIN AIR FILTER. CHECK ALL FLUID LEVELS AND TOP OFF AS NECESSARY. PERFORM BASIC SAFETY INSPECTION
- HAZARDOUS DISPOSAL
RALPH S. gave our service a 5 star review on 7/8/2021
