Ford

Home / Ford

We Service and Repair all Ford cars

  • 2012 Ford Pickup

    Ford Pickup
    Mileage
    114,921
    Service Date
    5/16/2024
    Services Performed
    • SAVI RANCH AUTOMOTIVE OIL CHANGE SPECIAL.
    • LUBRICATE AND CHECK CHASSIS. CHANGE OIL AND OIL FILTER. CHECK ENGINE AIR FILTER, BREATHER FILTER, AND CABIN AIR FILTER. CHECK ALL FLUID LEVELS AND TOP OFF AS NECESSARY. PERFORM BASIC SAFETY INSPECTION
    • HAZARDOUS DISPOSAL
    • CHECK AND ADJUST TIRE PRESSURE TO RECOMMENDED SPECIFICATIONS ON DOOR JAM.
    • Remove cover. Remove old gasket material, drain old fluid. Inspect internals and reassemble with new gasket. Install new fluid to proper level. Road test vehicle for proper operation.
    • HazMat disposal
     
    DANNY Y. gave our service a 5 star review on 5/17/2024
  • 2011 Ford Fusion

    Ford Fusion
    Mileage
    110,531
    Service Date
    4/30/2024
    Services Performed
    • CUSTOMER REQUESTS INSTALLATION OF NEW PASSENGER FRONT WHEEL COVER
    • INSTALL NEW WHEEL COVER
     
    Linda E. gave our service a 5 star review on 5/3/2024
  • 2016 Ford F-150

    Ford F-150
    Mileage
    75,148
    Service Date
    4/11/2024
    Services Performed
    • OIL PAN AND VALVE COVER
    • LABOR TIME ACCORDING TO TSB: ENGINE OIL PAN &/OR GASKET, VALVE COVER GASKET – Remove & Replace – 2.7L Eng,RWD
    • CLEAN AND REMOVE DEPOSITS IN THE FUEL AND AIR INDUCTION SYSTEM THAT CONTRIBUTE TO DRIVEABLILITY PROBLEMS SUCH AS HESITATION, SURGE, STALL, HARD STARTING, ROUGH IDLE AND LOSS OF POWER.
    • REPLACE SPARK PLUGS (COMBINED )
     
    Mike E. gave our service a 5 star review on 4/22/2024
  • 2016 Ford F-150

    Ford F-150
    Mileage
    74,635
    Service Date
    3/22/2024
    Services Performed
    • -PERFORM THE ROAD TEST WITH VEHICLE DROVE UP HILLS BUT WAS UNABLE TO RECREATE CUSTOMER'S CONCERN -RETRIEVED TROUBLE CODES FROM VEHICLE WITH SCAN TOOL AND PULLED CODES: -P0706: TRANSMISSION RANGE SENSOR A CIRCUIT RANGE / PERFORMANCE -P0707: TRANSMISSION RANGE SENSOR A CIRCUIT LOW -P0717: INPUT / TURBINE SHAFT SPEED SENSOR A CIRCUIT NO SIGNAL -P1702: TR(TRANSMISSION RANGE) SENSOR CIRCUIT INTERMITTENT FAULT -P1921: TRANSMISSION RANGE SIGNAL -PROCEEDED TO PERFORM VISUAL INSPECTION OF ELECTRICAL CONNECTOR LEADING TO INPUT TURBINE SHAFT SPEED SENSOR LOCATED BACK RIGHT OF TRANSMISSION, FOUND NO OBVIOUS FAULTS AT THIS TIME DISCONNECTED ELECTRICAL CONNECTOR TO INSPECT FOR POSSIBLE CORROSION BUILDUP BUT FOUND NONE AT THIS TIME -GIVEN THE CURRENT TROUBLE CODES THAT ARE PRESENT IT IS INDICATIVE OF A FAILURE WITHIN THE AUTOMATIC TRANSMISSION CONDUCTOR PLATE, HOWEVER TO PERFORM FURTHER CONFIRMATION TESTING IT IS REQUIRED TO REMOVE THE CONDUCTOR PLATE FROM THE TRANSMISSION WHICH WILL REQUIRE A TEARDOWN *AT THIS TIME OF DIAGNOSIS IT IS RECOMMENDED TO REPLACE THE THE AUTOMATIC TRANSMISSION CONDUCTOR PLATE HOWEVER FURTHER TESTING TO CONFIRM COULD BE MADE WHEN CONDUCTOR PLATE IS REMOVED
    • CONDUCTOR PLATE – Remove & Replace – Main Control Unit (Leadframe)
    • HAZARDOUS DISPOSAL
    • -UPON REMOVAL OF TRANSMISSION PAN AND VALVE BODY REMOVED CONDUCTOR PLATE FROM VALVE BODY PERFORM BENCH RESISTANCE TESTING TO AUTOMATIC TRANSMISSION CONDUCTOR PLATE. -USING MULTIMETER TESTED RESISTANCE AT PINS PCM CONNECTION (PIN 6) AND TESTED A RESISTANCE OF 8.1 OHMS RANGE SHOULD NOT BE GREATER THAN 3.0 OHMS INDICATION OF INTERNAL FAILURE OF AUTOMATIC TRANSMISSION CONDUCTOR PLATE *AT THE TIME OF DIAGNOSIS NO FURTHER TESTING OF CONDUCTOR PLATE IS NEEDED AND IT IS RECOMMENDED TO CONTINUE WITH REPLACEMENT OF AUTOMATICALLY CONDUCTOR PLATE
    • SAVI RANCH AUTOMOTIVE OIL CHANGE SPECIAL.
    • LUBRICATE AND CHECK CHASSIS. CHANGE OIL AND OIL FILTER. CHECK ENGINE AIR FILTER, BREATHER FILTER, AND CABIN AIR FILTER. CHECK ALL FLUID LEVELS AND TOP OFF AS NECESSARY. PERFORM BASIC SAFETY INSPECTION
    • CHECK AND ADJUST TIRE PRESSURE TO RECOMMENDED SPECIFICATIONS ON DOOR JAM.
    • HAZARDOUS DISPOSAL
     
    Mike E. gave our service a 5 star review on 3/22/2024
  • 2015 Ford Edge

    Ford Edge
    Mileage
    106,142
    Service Date
    10/3/2023
    Services Performed
    • U3003 BATTERY VOLTAGE PAST CODE CURRENT VOLTAGE ON CAR IS 14.5 VOLTS PP0460 FUEL LEVEL SENSOR A CIRCUIT ERROR PAST CODE NOT CURRENT P1016 WASTEGATE CONTROL PRESSURE ABOVE EXPECTED VALUE
    • CUSTOMER REQUESTS TO HAVE TPMS SENSOR REPLACED AS WELL
    • REMOVE AND REPLACE HOSE ASSEMBLY
    • REMOVE AND REPLACE FOUR TPMS SENSORS (INCLUDES PROGRAMMING)
     
    DEBBIE B. gave our service a 5 star review on 10/3/2023
  • 2014 Ford Fiesta

    Ford Fiesta
    Mileage
    56,326
    Service Date
    7/31/2023
    Services Performed
    • -PERFORM COOLANT PRESSURE SYSTEM TEST AT 25 PSI PER MANUFACTURER SPEC, DESERVE A PRESSURE LOSS OF 9 PSI. FOUND A ACTIVE COOL LEAK FROM BOTTOM OF THE VEHICLE, REMOVED AIR INTAKE TO INSPECT COOLANT LEAK AND FOUND LEAK FROM UPPER COOLANT PIPE LINE LEADING FROM COOLANT RESERVOIR TO BACK SIDE OF ENGINE *AT THIS TIME OF DIAGNOSIS RECOMMEND REPLACEMENT OF HOSE ASSEMBLY AND RECHECK COOLANT SYSTEM
    • REMOVED AND REPLACED RECOVERY TANK HOSE AND BLEED OUT AIR POCKETS FROM SYSTEM, PERFORMED ROAD TEST ON VEHICLE AND CHECKED FOR BUBBLES AT COOLANT RESERVOIR AND BUBBLES WERE NOT PRESENT, COOLANT SYSTEM IS OPERATING NORMAL AT THIS TIME
    • HAZARDOUS DISPOSAL
     
    LEM C. gave our service a 5 star review on 8/6/2023
  • 2019 Ford F-150

    Ford F-150
    Mileage
    67,937
    Service Date
    3/14/2023
    Services Performed
    • CUSTOMER STATES THE STRUTS ARE LEAKING PER LAST TIME HE WENT FOR NEW TIRES
    • SAVI RANCH AUTOMOTIVE OIL CHANGE SPECIAL.
    • LUBRICATE AND CHECK CHASSIS. CHANGE OIL AND OIL FILTER. CHECK ENGINE AIR FILTER, BREATHER FILTER, AND CABIN AIR FILTER. CHECK ALL FLUID LEVELS AND TOP OFF AS NECESSARY. PERFORM BASIC SAFETY INSPECTION
    • CHECK AND ADJUST TIRE PRESSURE TO RECOMMENDED SPECIFICATIONS ON DOOR JAM.
    • HAZARDOUS DISPOSAL
     
    BRIAN D. gave our service a 5 star review on 3/14/2023
  • 2013 Ford Flex

    Ford Flex
    Mileage
    112,212
    Service Date
    2/1/2023
    Services Performed
    • CUSTOMER STATES CHECK ENGINE LIGHT WAS ON FR A DAY THEN WENT AWAY HAS A HISTORY CODE IS P0430 CATALYST SYSTEM EFFICIENCY LESS THEN THRESHOLD BANK 2 WATCHED LIVE DATA FOR ANY OUT OF THE ORDINARY READINGS EVERYTHING IS OPERATING PROPERLY CAN NOT DUPLICATE CUSTOMERS CONCERN AT THIT TIME VEHICLE HAS IT A HISTORY NOT CURRENT OR PENDING NO FAULTS FOUND RECOMMEND CLEARING CODES DRIVE VEHICLE FOR 100 MILES TO COMPLETE DRIVER CYCLE IF CHECK ENGINE LIGHT COMES ON RECHECK
    • CUSTOMER STATES THE CEL IS NOW OFF. THE LIGHT WAS ONLY ON FOR A DAY. CHECK AND ADVISE
    • WINDSHIELD WIPER BLADE SET INSTALLATION (COMPLIMENTARY)
    • REMOVE AND REPLACE ENGINE AIR FILTER
    • REMOVE AND REPLACE CABIN AIR FILTER
    • CLEAN AND REMOVE DEPOSITS IN THE FUEL AND AIR INDUCTION SYSTEM THAT CONTRIBUTE TO DRIVEABLILITY PROBLEMS SUCH AS HESITATION, SURGE, STALL, HARD STARTING, ROUGH IDLE AND LOSS OF POWER.
    • SPARK PLUGS – Remove & Replace – Normally Aspirated – [Includes: R&I Upper Intake Manifold.]
    • ALTERNATOR DRIVE BELT – Remove & Replace – Normally Aspirated – [Includes: Serpentine and V-Belt type Belt(s).]
     
    KIM G. gave our service a 5 star review on 2/1/2023
  • 2005 Ford Explorer

    Ford Explorer
    Mileage
    160,365
    Service Date
    10/17/2022
    Services Performed
    • FOUND THAT THE STARTER HAS FAILED, REPLACED UNDER WARRANTY ALSO CLEANED BOTH BATTERY TERMINAL CONNECTORS BECAUSE THEY WERE CAUSING RESISTANCE TO THE STARTER. SYSTEM NOW WORKING AS NORMAL
    • CUSTOMER WILL BE OUT OF THE STATE UNTIL THE 24TH
     
    DAN B. gave our service a 5 star review on 10/28/2022
  • 2010 Ford Escape

    Ford Escape
    Mileage
    88,074
    Service Date
    2/22/2022
    Services Performed
    • TEST DROVE VEHICLE AND RIGHT ON START UP WHILE MOVING SLOWLY FROMT BRAKES SQUEAKED, ON TEST DRIVE NO OTHER NOISES WERE HEARD – BRAKE FLUID SAMPLE: 1% MOISTURE CONTENT AND 30ppm COPPER CORROSION LEVEL – FRONT TIRE MEASUREMENTS: 5/32 – REAR TIRE MEASUREMENTS: 8/32 – FRONT BRAKE PAD MEASUREMENTS: 3mm LEFT ON FRONT BRAKE PADS – FRONT ROTORS: MACHINABLE – REAR BRAKE SHOE MEASUREMENTS: 4MM LEFT ON REAR BRAKE SHOES (OK) RECOMMEND REPLACING FRONT BRAKE PADS AND MACHINING ROTORS RECOMMEND CLEANING AND ADJUSTING REAR BRAKES RECOMMEND TIRE ROTATION
    • Replace front brake pad linings and machine front brake disc rotors. Clean and lubricate brake calipers and slide mechanisms. Road test vehicle.
    • BRAKES – Adjustment – [DOES NOT include adjust Parking Brake.]
    • TIRE ROTATION
     
    ANNE M. gave our service a 5 star review on 2/22/2022